Section 329IAC13-7-6. Analysis plan

   (a) Owners or operators of used oil processing and re-refining facilities must develop and follow a written analysis plan describing the procedures that will be used to comply with the analysis requirements of section 4 of this rule and, if applicable, 329 IAC 13-9-3. The owner or operator must keep the plan at the facility.

  (b) At a minimum, the plan must specify the following:

(1) Whether sample analyses or knowledge of the halogen content of the used oil will be used to make this determination.

(2) If sample analyses are used to make this determination, the following requirements shall apply:

(A) The sampling method used to obtain representative samples to be analyzed. A representative sample may be obtained using either:

(i) one (1) of the sampling methods in 40 CFR 261 Appendix I; or

(ii) a method shown to be equivalent under 40 CFR 260.20 and 40 CFR 260.21.

(B) The frequency of sampling to be performed, and whether the analysis will be performed on-site or off-site.

(C) The methods used to analyze used oil for the parameters specified in section 4 of this rule.

(3) The type of information that will be used to determine the halogen content of the used oil.

  (c) At a minimum, the plan must specify the following if 329 IAC 13-9-3 is applicable:

(1) Whether sample analyses or other information will be used to make this determination.

(2) If sample analyses are used to make this determination, the following requirements shall apply:

(A) The sampling method used to obtain representative samples to be analyzed. A representative sample may be obtained using either:

(i) one (1) of the sampling methods in 40 CFR 261 Appendix I; or

(ii) a method shown to be equivalent under 40 CFR 260.20 and 40 CFR 260.21.

(B) Whether used oil will be sampled and analyzed prior to or after any processing or re-refining.

(C) The frequency of sampling to be performed, and whether the analysis will be performed on-site or off-site.

(D) The methods used to analyze used oil for the parameters specified in 329 IAC 13-9-3.

(3) The type of information that will be used to make the on-specification used oil fuel determination.

(Solid Waste Management Division; 329 IAC 13-7-6; filed Feb 3, 1997, 9:15 a.m.: 20 IR 1507; readopted filed Jan 10, 2001, 3:25 p.m.: 24 IR 1535)